HumidiCup® S1 Electronic Cigar Humidifier, Small Size for 40-150 Cigar Count Humidor, Slim Profile For Desktop Humidors, 60% to 80% Setting Range

Price: $89.00
(as of Apr 15, 2023 11:52:10 UTC – Details)

Product Description

HumidiCup S1 is an electronic cigar humidifier automatically keep cigars in desired humidity in a humidor. S1 is similar as M1 but with slim profile cartridge for desktop humidors up to 3 cubic feet size with 150 cigar capacity. The humidity inside the humidor is measured by a built-in high accurate humidity sensor. The micro-processor controls the quiet fan to run to blow moist airflow into the humidor according to the measured humidity value.The humidifier is factory set at 70% and can be adjusted from 60% to 80% by user to best taste. -5~+5 calibration date can be set by user. Since 2023, we have optimized the design to prevent sensor from long-term drift caued by potential environmental polltion.

Features:

Slim profile (2.3″ height) be suitable for desktop humido.Low drirt with Membrane protection to the sensor.Accurate and reliable.Fog free humidifierAudio and display alerts for ‘lack of water’.

Frequent Questions & Answers:

1. Why dose the fan stop working?

The fan stops when the measured environmental humidity reaches the setting value or is higher than the setting value and runs when the environmental humidity is lower than the setting value.

2. Why does the humidifier display a higher much value than that of another accurate hygrometer?

Make sure the vents on the sides of the humdifiier has not been blocked especially the left side of the device. Bloicking the device will cause the moist air cannot escape. Drift of the built-in sensor also will cause higher readings. Just refer to the question #10 for how to make sure the humidfiier is accurate. Some chemical liquid like Moisturizing liquid (Propylane Glycol）will cause a drift of sensor.

3. How to install the humidifier?

Fill cartridge with CLEAN WATER until sponge is saturated. Pour out excess water from cartridge. Push the control unit until it clicks into place with alignment marks are aligned.

4. How often to add water to S1 for a table humidor?

Normally once a month and depends on the size, sealing status of humidor and environmental humidity.

5. Can the Humidifiers be used with moisturizing liquid?

Distilled water is recommended. Since 2023,

Distilled water is recommended. Since 2023, we have optimized the design to prevent sensor from long-term drift caued by some volatile compound.

6. Can the Humidifiers be used with a battery?

The humidifiers can be used with a 5V external battery BUT most cellphone power banks with low current shut-down function will shut down when the fan stops.

7. Why does my S1(or M1) indicate ‘H2O’ however the cartridge is full of water?

‘H2O’ indicates ‘lack of water’ when the measured humidity value is continuously 10% at least lower than the setting humidity value for two hours. If the humidor is too big, or not sealed well, or with cooling function and the humidifiers are not enough to raise the humidity to close to setting value for two hours, the humidifier could alarm for ‘lack of water’ . We got this issue reported mostly from a cooled cabinet humidor application. Adding more M1 humidifiers to expand the humidification capability normally can resolve the issue.

8. Can the humidor be sealed well with the power cord?

The thin paper ribbon cable be used for passing through the seam of the lid and keep air-tightness.

9. How to place the humidifier(s) in a humidor?

Make sure the vents of the humidifier is not blocked. It is recommended the humidifier to be placed with the LED up toward. Keep at least two inches cdistance from the vents on the sides of humidifier to the cigars or walls of the humidor. For cabinet application, it is recommended to place the humidifier at the center of the top shelve and if there is second humidifier, to place the second one on the center of the middle shelve.

10. How to make sure the hygrometer of the humidifier is accurate?

Remove the cartridge and put the white control unit (hygrometer) with another hygrometer you are sure its accuracy together on the table. Compare the displayed humidity value of them after one hour. Stay at least two feet away from them and DO NOT touch them by your hands during the test.

Installation

STEP 1

Fill CLEAN WATER in cartridge slowly until sponge inside is fully saturated. Power out excess water from cartridge and wipe dry outsides.

STEP 2

Locate the control unit to cartridge and make sure the align marks aligned.

STEP 3

Connect the power cord and ribbon cable to the humidifier and plug the adapter to wall outlet.

STEP 4

Set desired humidity value then put it in suitable position of humidor.

Easy Cigar Life

Set the desired humidity value, connect power, put it in humidor to let the humidifier to keep humidity level automatically. You may not need to care your cigars everyday as usual. There is audio alert to remind you to add water.

Quality & Service

100% function and accuracy inspected in factory.HumidiCup support team responses your inquiries within 24 hours. Please send message to us on Amazon , or send email to our company support email if you intend to contact HumidiCup.

One year warranted by HumidiCup. Quick CS response.
+/-3% Accuracy with low drift.. 100% factory inspected.
Robust and easy use.. Audio and display for ‘lack of water’